# FC_V1 Firmware Thresholds and Parameters ## Purpose This document records the principal configurable parameters used by the final FC_V1 flight-event detection and recovery-control firmware. Values in this document must correspond to the frozen final FC_V1 firmware. ## Launch Detection | Parameter | Value | Purpose | |---|---:|---| | Acceleration threshold | [FROM FINAL CODE] | Primary simulated launch-event criterion | | Altitude confirmation threshold | [FROM FINAL CODE] | Additional launch confirmation | | Confirmation duration/count | [FROM FINAL CODE] | Rejects transient measurements | ## Apogee Detection | Parameter | Value | Purpose | |---|---:|---| | Peak-altitude decrease threshold | [FROM FINAL CODE] | Detects decrease from recorded peak altitude | | Confirmation condition | [FROM FINAL CODE] | Confirms apogee before recovery actuation | ## Landing Detection | Parameter | Value | Purpose | |---|---:|---| | Altitude-stability threshold | [FROM FINAL CODE] | Evaluates approximately stationary altitude | | Acceleration/stability threshold | [FROM FINAL CODE] | Evaluates stationary condition | | Confirmation duration | [FROM FINAL CODE] | Prevents premature landing declaration | ## Recovery Servo | Parameter | Value | Purpose | |---|---:|---| | Servo GPIO | 18 | Recovery actuator control | | STOWED position | [FROM FINAL CODE] | Normal/pre-recovery position | | DEPLOYED position | [FROM FINAL CODE] | Recovery-command position | ## Recovery Beacon | Parameter | Value | Purpose | |---|---:|---| | Buzzer GPIO | 25 | Audible recovery indication | | Activation state | LANDED | Post-landing recovery indication | | Timing behaviour | [FROM FINAL CODE] | Buzzer operating sequence | ## Sensor Acquisition | Parameter | Value | |---|---:| | I²C SDA | GPIO 21 | | I²C SCL | GPIO 22 | | BMP280 configuration | [FROM FINAL CODE] | | MPU6050 configuration | [FROM FINAL CODE] | | Sensor update interval | [FROM FINAL CODE] | ## Engineering Note The FC_V1 thresholds were developed for functional prototype and controlled bench verification. They must not be interpreted as validated flight parameters for an actual launch vehicle. Future flight-oriented parameters should be established through sensor characterization, recorded test data and representative ground/flight testing.