# FC_V1 Hardware Pinout ## ESP32 Interface Allocation | ESP32 Pin | Connected Hardware | Function | |---|---|---| | GPIO 21 | BMP280 + MPU6050 + OLED | I²C SDA | | GPIO 22 | BMP280 + MPU6050 + OLED | I²C SCL | | GPIO 18 | SG90 Servo | Recovery actuator signal | | GPIO 25 | Buzzer | Audible indication | | GPIO 26 | Green LED | Status indication | | GPIO 27 | Yellow LED | Status indication | | GPIO 32 | Blue LED | Flight-state indication | | GPIO 33 | Red LED | Recovery/warning indication | | GPIO 14 | Push Button | ARM / DISARM / RESET input | | 3.3 V | Sensor/display supply | Logic power | | GND | All subsystems | Common electrical reference | ## I²C Devices | Device | Interface | |---|---| | BMP280 | Shared I²C bus | | MPU6050 | Shared I²C bus | | SSD1306 OLED | Shared I²C bus | ## Servo Interface The SG90 servo uses: - Signal → GPIO 18 - Power → appropriate servo supply - Ground → common system ground The servo must not be powered from the ESP32 3.3 V output. ## Push-Button Interface The user push button is connected between: `GPIO 14 → Push Button → GND` The firmware configures GPIO 14 using the ESP32 internal pull-up resistor. ## Status This pinout corresponds to the final FC_V1 integrated prototype and frozen V1.6.5 firmware configuration.